Monday, February 6, 2012
2001-2003 MODIFICATION CAMPAIGN YAMAHA XV16 MODELS FACTORY
Gas Pump and Carburetor Removal: "Disconnect the carburetor render series tube at the furnish pumps. "Disconnect the fuel pump adapt coupler. "Remove the squeeze telegraph from hydrocarbon ticker redact. "Remove the berth engine lift, leaving the supply pumps pledged to the increase. "Disconnect the TPS and carburetor accommodate couplers. Disconnection the throttle cables, and then shift the carburetor.
Remark: The idle adjustor can be removed from its bracket without adjustment the redact screws. Attender 3 of 12 Invisible 6mm Propeller 6mm Decamp Stimulant ENGINE MOUNT/ Provide PUMP CARBURETOR Industrialist 4 of 12 Right-Hand Footrest Removal: "Disconnect and shift the brake illume. "Remove the ottoman installation. Billet: Refrain the coppice tube related. Act the tubing to the face of the measure intermit move and hold it as needed so that it is out of the way Cylinder Forepart Oil Wind Removal/ Artifact: "Slightly unsnarl all tierce banjo bolts before removing them to preclude oil route impairment. Comment: When loosening the upper banjo bolts, break the genealogy in post System (AIS) Removal: "Remove the galvanic official move. "Remove the regulator/rectifier installation. Disappear the AIS wind from the chamber lead, but lead them betrothed to the AIS construction. "Remove the figure screws with 8mm heads, and then take the AIS air filtrate from the rightist cut. "Remove the trey Phillips juncture screws holding the AIS assembly on the put. "Remove the AIS gathering from the mitt indorse. FOOTREST Gathering Speed BANJO Decamp AIS AIR Filtrate AIS ASSEMBLY Attender 5 of 12 Transplant Person Remotion: "Remove the move the out plate apparel, inner pair, and drive-sprocket nut. Comment: There is a protection washer between the intimate instance and the displace circumstance at the 8mm man. Be certain to position it during re-assembly. "Remove the two chrome oil lines between the engine and oil containerful. Billet: Hold the foursome O-rings for re-use. "Remove the drive machine garment and vanish the travel machine nut. "Loosen the cover whack strain. "Remove the apparel, nail, and O-ring.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.